Vanderbilt SPC42 Series Installation & Configuration Manual page 207

17.9.2.1.2
Vanderbilt
WARNING
Your system will not comply with EN standards if you enable a function key to set
the system without a valid PIN being required.
Function Keys
Area Select the area is to be controlled by the function key.
Function Select the function to be performed by this key in this area..
Area Select an area if the indicator module is located in a secure area.
Visual Indication
Indicator There are 8 indicators / LEDs on the right and 8 indicators / LEDs on the left side.
Function The function that is indicated by this LED.
Function On Select the colour and the state for every indicator if the selected function is ON.
Function Off Select the colour and the state for every indicator if the selected function is OFF.
Change function Press this button to change the function for this indicator. The function can be
enabled or used for a system, area, zone or keyswitch.
Audible Indications
Alarms Select if the alarms should be audible.
Entry / Exit Select if entry / exit should be audible.
Key press Select if keypress should be audible.
Deactivation
Calendar Select if indicator expander should be limited by calendar.
Mapping gate Select if indicator module should be limited by a mapping gate.
Keyswitch Select if indication module should be limited by a keyswitch.
Keypad Select if indicator module should be limited to a valid PIN entered on a keypad.
(see warning above)
Card reader Select if indicator module should not be activated until a valid card/fob is
presented to the built-in card reader.
Configuring a Keyswitch Expander
1. Select Settings > X-Bus > Expanders.
2. Click one of the keyswitch identifying parameters.
 The following dialog is displayed.
Installation & Configuration Manual
Engineer programming via the browser
Configuration
17
207
A6V10276959
01.05.2016