Vanderbilt SPC42 Series Installation & Configuration Manual page 205

Vanderbilt
Configure the following fields:

Description For appearance on device LEDs.
Volume Limit Audio Expander Only: Speaker volume for the Audio Expander and satellites
(WAC 11). They are all wired in parallel. Note that the speaker on WAC 11 has a
potentiometer for fine-tuning the volume. Range is 0 min - 7 max or disabled.
Auxillary Channnel Audio Expander Only: This option should be enabled if satellites (WAC11) are
connected to this expander.
Note: This option, if enabled, powers the satellite microphones. The satellite
speakers are always enabled regardless of this setting.
End Of Line Select the correct End of Line (default: DEOL 4K7). This setting should match the
actual wiring of the input on the controller or expander. See page [➙ 72].
(Zone) Description Provide a description for allocated zone.
(Zone) Type Select the zone type. See page [➙ 350].
Area Select the area.
Attributes Assign attributes as desired. See page [➙ 347].
Outputs / PSU outputs (Displayed for the SPCP355.300 Smart PSU ONLY)
Output The numbered output. The value in parentheses corresponds to the physical
output on the PSU board.
Description Provide description for output.
Change type Change the type of output as necessary.
Attributes Assign attributes to the output.
Test Test the output.
Output monitor Select which outputs are to be monitored.
Note: The parallel resistor, diode and required load must be applied before
enabling this option. The SPCP355.300 must perform a calibration before
monitoring starts. See Supervised Outputs [➙ 57] for more information.
Primary battery Tick this box if there is no secondary battery connected to the PSU
only
When expanders are added or removed:
Click Reconfigure to implement changes.

See also
 Wiring the system [➙ 72]
Installation & Configuration Manual
Engineer programming via the browser
Configuration
17
205
A6V10276959
01.05.2016