Vanderbilt SPC42 Series Installation & Configuration Manual page 198

Engineer programming via the browser
17
Configuration
17.9.1.2.1
198
Vanderbilt
Output Type
System Output: Select the type from the dropdown menu. (See Output Types

and Output Ports [➙ 198])
Area Output: Only if (multiple) Areas is activated in menu Panel Settings >

System Settings > Options. Select an area and the type of system output for this
area. (See Output Types and Output Ports [➙ 198])
 Zone Mapping: Select which zone should be mapped.
 Mapping Gate: Select which mapping gate should be mapped.
Door Output: Select the door number and the type of system output for the door.

(See Output Types and Output Ports [➙ 198])
Keyswitch: Select the node ID for the required keyswitch and the required key

position to map to this output.
Description Enter a text describing the output (max. 16 characters). This text will also appear on
the browser and keypad.
Output
Mode: Select the operational mode. Continuous follows output type; Pulsed

Configuration
toggles on and off when output type is active; Momentary generates a pulse
when output type activates.
Retrigger: Tick the box to retrigger momentary outputs.

 On Time: Enter the On time that applies to momentary and pulsed outputs.
 Off Time: Enter the Off time that applies to pulsed outputs.
 Invert: Tick this box to invert the physical output.
Log: Tick this box to log the output state changes to the event log.

Calendar: Select if necessary the desired calendar. See page [➙ 251].

See also
 Calendars [➙ 251]
Outputs types and output ports
Each output type can be assigned to one of the 6 physical output ports on the SPC
controller or to an output on one of the connected expanders. Output types that are
not assigned to physical outputs act as indicators of events on the system and may
be logged and/or reported to remote central stations if required.
Installation & Configuration Manual A6V10276959
01.05.2016