Vanderbilt SPC42 Series Installation & Configuration Manual page 184

Engineer programming via the browser
17
Users
184
Vanderbilt
3. Enter a User ID that is not currently being used. If you enter an ID that is
already used, an 'ID Unavailable' message is displayed.
4. Provide a User Name (maximum 16 characters and case sensitive).
5. To automatically generate a User PIN for a new user, click the Generate PIN
button. Change the PIN if required. Enter 0 if PIN is not required.
 Note: To comply with INCERT approvals, the user's PIN code must contain
more than 4 digits.
6. You can also limit access to the system for this user by ticking the Date Limit
box and entering a To and From date in the date fields.
 User Alerts displays the status of the user's PIN. For example, It displays
the number of days remaining before the PIN expires, if Periodic changes
are enabled in the system PIN Policy.
7. Select the appropriate User Profile [➙ 186] for this user.
8. Select Duress Enable for this user if required. The number of PINs allocated for
duress (PIN +1 or PIN+2) is set in System Options [➙ 222].
Duress option only available on this screen if 'User Duress' is enabled for the
system in System Options. If Duress is enabled for this user, then consecutive
user PINs for other users (i.e. 2906, 2907) are not permitted, as entering this PIN
from the keypad would activate a user duress event.
Access Control
Attribute
Card Number
Void Card
Extended Time
PIN bypass
Priority
Installation & Configuration Manual
Description
Enter card number. Enter 0 to unassign this card.
Check to temporarily disable this card.
Extend door timers when this card is present.
Access a door without PIN on a door with PIN reader.
Priority cards are stored locally in the door controllers and
will grant access in case of a technical fault where the door
controller cannot communicate with the control panel.
The maximum number of priority users is:
A6V10276959
01.05.2016