Vanderbilt SPC42 Series Installation & Configuration Manual page 25

Vanderbilt
6.4.1 For all the unsetting methods in the SPC system there is an audible
indication to the user that the system has been unset successfully. This is in the
form of a beep sequence from the CIE.
6.4.2 Prevention of entry to the supervised premises before the intruder alarm
system (IAS) is unset:
a) Unlocking the initial entry door causes the IAS to be unset;
Compliance by SPC if KEYARM zone type is used with the UNSET attribute only.
This zone type must not be used for setting.
b) Unsetting the IAS by the user before entering the supervised premises causes
or permits the initial entry door to be unlocked.
Compliance by SPC by unsetting using an access card reader on an entry reader
with the UNSET option, or an input from a third party access system to a KEYARM
zone with an UNSET attribute.
6.4.3 Prevention of entry to the supervised premises before all means of intruder
alarm confirmation have been disabled:
a) Unlocking the initial entry door causes all means of confirmation to be disabled
Operation not permitted by SPC.
b) Disabling all means of confirmation by the user before entering the supervised
premises causes or permits the initial entry door to be unlocked
Operation not permitted by SPC.
6.4.4 Opening the initial entry door disables all means of intruder alarm
confirmation
Operation not permitted by SPC.
6.4.5 Completion of unsetting using a digital key
a) Operation of a digital key before entering the supervised premises (for example,
via radio)
SPC satisfies this clause when the installer installs a PACE reader (e.g. SPCK421)
outside the premises.
b) Operation of a digital key after entering the supervised premises from a location
as near as practicable to the initial entry door.
This functionality is provided by use of a PACE reader (e.g. SPCK421) near the
entry door of a premises.
Refer to the following sections in this manual:
Zone types [➙ 347]

Zone attributes [➙ 350]

WARNING
Your attention is drawn to the fact that by allowing this method of unsetting, if an
intruder succeeds in forcing the initial entry door, the police will not be called,
regardless of the intruder's further progress through the premises.
This method of unsetting the intruder alarm system might be unacceptable to your
insurers.
6.4.6 Unsetting in conjunction with an alarm receiving centre (ARC)
Installation & Configuration Manual
Directives and standards
EU directives
A6V10276959
01.05.2016
3
25