Vanderbilt SPC42 Series Installation & Configuration Manual page 283

Vanderbilt
ATP Sequence No.
ATP Unique ID
ATP Name
SPT Account Code
ARC Connection
Number 1
Number 2
Modem Select
Test Calls
Test Call Mode (Non-active ATP)
Test Call Mode (Active ATP)
Time of first test call
Event Protocol
Protocol
Event Profile
ATP Faults
ATP Monitoring Fault
Installation & Configuration Manual
Engineer programming via the browser
Configuring Communications
This field displays the sequence number of the
ATP in the ATS configuration. Number 1 is
primary, numbers 2 - 10 are backup
This ID uniquely identifies the ATP to the RCT
Enter a name for the ATP
Enter a number to uniquely identify the panel to
the RCT (1 - 999999)
Phone number 1
Phone number 2
Select the modem to be used.
Modem 1

Modem 2

Select the mode for sending test calls when the
ATP is in non-active mode. Default: 24 hours.
Test calls disabled

Test call every 10 minutes

Test call every 1 hour

Test call every 24 hours

 Test call every 48 hours
 Test call every 7 days
 Test call every 30 days.
Select the mode for sending test calls when the
ATP is an active ATP. Default: 24 hours.
Test calls disabled

Test call every 10 minutes

Test call every 1 hour

Test call every 24 hours

Test call every 48 hours

Test call every 7 days

Test call every 30 days.

Time of first test call after reset or ATS
initialization.
Send Immediately (default)

or

Select a half hour interval between 00:00 and

23:30
Protocol used in communication.
SIA

SIA Extended 1

SIA Extended 2

Contact ID

Select the Event Profile which defines how and
which events are transmitted on this ATS.
Use ATS Setting

Default Event Profile

Default Portal Event Profile

All events

Custom Event Profile

Select to generate an ATP fault if the ATP
17
283
A6V10276959
01.05.2016