Vanderbilt SPC42 Series Installation & Configuration Manual page 174

Engineer programming via the browser
17
Panel status
174
Vanderbilt
Description Text description of the door controller (max. 16 characters).
Type The type of expander detected (=door controller).
S/N The serial number of the door controller.
Version The firmware version of the door controller.
Comms The status of the door controller (online or offline).
Status The status of the door controller (OK, Fault).
PSU Specifies if the door controller has a PSU.
Performable actions
Refresh Click on the refresh button to update the status of the system alerts.
To view more status information:
Click on a door controller's identifying parameters (ID, description, type, serial

number) to display further status details.
Communication The physical status (OK, Fault) and the programmed status (OK, Isolated,
Inhibited) of the keypad cable connection to the expander.
Cabinet Tamper The physical and programmed status of the expander cabinet tamper.
Fuse Fault The physical and programmed status of the door controller fuse.
Code Tamper Status of the user's PIN. Multiple failed attempts result in an alert.
Performable actions
Restore Alerts Click the button to restore all alerts on the panel.
Inhibit Click this button to inhibit a fault condition. The inhibit operation will disable
that fault or zone for one arming period only.
Inhibit operation is not available in Security Grade EN 50131 Grade 3.
Isolate Click this button to isolate that zone. Isolating a zone will de-activate that zone
until such time as the zone is explicitly de-isolated again. It is recommended
that you exercise caution when isolating zones as those zones will not be
active every time the system is SET.
Installation & Configuration Manual A6V10276959
01.05.2016