Vanderbilt SPC42 Series Installation & Configuration Manual page 291

Vanderbilt
1. Enter a Name to identify the command profile.
2. Select an Authentication Mode (Command User or Panel User, Command User
Only, or Any Panel User) from the dropdown menu.
NOTICE
The default Command User Name provides an out of the box user that quickly
and easily enables control of the panel from SPC Com XT. It enables a broad
range of commands. For example, the default command user can set all areas or
control all zones. For tighter control, for example to only allow setting of certain
areas, you can set up a customised command profile with a defined set of rights.
You cannot delete the Default Command Profile, the Default Portal Command
Profile or a command profile that is assigned to an ATS.
3. Enter the name of the command profile user in the Command User Name field.
This must match the Authentication User Name field in SPC Com XT.
4. Enter the password of the command profile user in the Command Password
field. This must match the authentication User PIN or Password field in SPC
Com XT.
5. Select the Live Streaming Mode (Disabled, Only after alarm event, Always
available, System is fullset) to determine the streaming privacy options. Always
Available generates the highest volume of data.
6. Under Command Filter, select the commands to enable. For a full list of
commands, see FlexC Commands [➙ 360].
7. Select the commands to log.
8. Click Save.
9. Click Back to view the command profile in the Command Profiles table.
10. To change a command profile, click the Edit button (pencil icon) next to a
command profile.
Installation & Configuration Manual
Engineer programming via the browser
Configuring Communications
17
291
A6V10276959
01.05.2016