Vanderbilt SPC42 Series Installation & Configuration Manual page 300

Engineer programming via the browser
17
Configuring Communications
300
Vanderbilt
Check any of the following boxes if you want to initiate a remote call to an EDP
Receiver to notify it of the particular event.
Alarms Alarms are activated.
Alarm Restores System alarms are restored.
Confirmed Alarms Alarms confirmed by multiple zones
Alarm Abort Alarm Abort events. Alarms are aborted after a valid user code is entered
via the keypad after a confirmed or unconfirmed alarm,
Faults Faults and tampers are activated.
Fault Restores Fault or tamper alarms are restored.
Zone state Report all zone input state changes.
Settings System is Set and Unset.
Early/Late Unscheduled setting and unsetting of the system.
Inhibits Inhibit and isolate operations are performed on the system.
Door Events Door events are activated. Only works with SIA protocol.
Other All other types of events are detected on the system.
Other (Non standard)
Non supported SIA codes used with SPC COM XT including Camera
Online/Offline events.
Installation & Configuration Manual A6V10276959
01.05.2016