Vanderbilt SPC42 Series Installation & Configuration Manual page 211

17.9.2.2.2
Vanderbilt
Calendar Select if the keypad should be limited by calendar. See Calendar [➙ 251].
Mapping gate Select if keypad should be limited by a mapping gate.
Keyswitch Select if keypad should be limited by a keyswitch.
PACE Entry
Tick this box to disable the keys on the keypad during the entry time when a
PACE is configured on the keypad.
Areas
Location Select the secured area where the keypad is located.
Areas Select which areas can be controlled through keypad.
Options
Delay Fullset Select to configure a delayed set across all keypads. The location of the keypad
is ignored and all areas will perform a full exit time count down.
NOTICE
An area should be assigned to a keypad only if the keypad is inside the assigned
area, and if an entry/exit route is defined. If an area is assigned, when the
particular area is set or unset then entry and exit timers are used (if configured).
Other features related to entry/exit routes also become available. If no area is
assigned, the area is set or unset immediately and other entry/exit features are
not available
See also
 Calendars [➙ 251]
Editing a Comfort Keypad
1. Select Configuration > Hardware > X-Bus > Keypads.
2. Click one of the comfort keypad identifying parameters.
3. Configure the fields as described in the table below.
Installation & Configuration Manual
Engineer programming via the browser
Configuration
17
211
A6V10276959
01.05.2016