Vanderbilt SPC42 Series Installation & Configuration Manual page 169

Vanderbilt
Name Description
Communication The physical status (OK, Fault) and the programmed status (OK,
Isolated, Inhibited) of the X-BUS cable connection to the
expander.
Cabinet Tamper The physical and programmed status of the expander cabinet
tamper.
Fuse Fault The physical and programmed status of the expander fuse.
Controller Mains Fault The physical and programmed status of the mains supply to the
controller.
Battery Fault The physical and programmed status of the battery.
PSU Fault The physical and programmed status of the PSU.
OP Tamper The physical and programmed status of the tamper outputs on the
PSU.
Low Voltage Indication of battery low voltage status.
Performable actions
Name Description
Restore Alerts Click the button to restore all alerts on the panel.
Inhibit Click this button to inhibit a fault condition. The inhibit operation
will disable that fault or zone for one arming period only.
!
Inhibit operation is not available in Security Grade EN 50131
Grade 3.
Isolate Click this button to isolate that zone. Isolating a zone will de-
activate that zone until such time as the zone is explicitly de-
isolated again. It is recommended that you exercise caution when
isolating zones as those zones will not be active every time the
system is SET.
Installation & Configuration Manual
Engineer programming via the browser
17
Panel status
169
A6V10276959
01.05.2016