Chrysler Sebring 2004 Service Manual page 2586

DRIVER CURTAIN SQUIB CIRCUIT SHORT —
TEST
2 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Driver Curtain Airbag connector(s).
NOTE: Check connectors - Clean repair as necessary.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED CURTAIN AIRBAG
FACE DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO
THE AIR IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERI-
OUS OR FATAL INJURY.
Connect the appropriate Load Tool to the Driver Curtain Airbag connector(s).
WARNING: TURN IGNITION ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read active Airbag Control Module DTC's.
Does the DRBIII show DRIVER CURTAIN SQUIB CIRCUIT SHORT?
Yes → Go To 3
→ Replace Driver Curtain Airbag in accordance with the Service
No
3 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Airbag Load Tool from the Driver Curtain Airbag connector(s).
Disconnect the Airbag Control Module connector(s).
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool ACM Adapter to the ACM connector(s).
Measure the resistance between the Driver Curtain Squib Line 1 and Line 2 circuits
at the Driver Curtain Airbag connector.
Is the resistance below 10K ohms?
Yes → Repair Driver Curtain Squib Line 1 shorted to Line 2 circuit.
→ Replace the Airbag Control Module in accordance with Service
No
ACTION
Information.
Perform __AIRBAG VERIFICATION TEST - VER 1.
Perform __AIRBAG VERIFICATION TEST - VER 1.
Information. WARNING: IF THE AIRBAG CONTROL MODULE
IS DROPPED AT ANY TIME, IT MUST BE REPLACED.
Perform __AIRBAG VERIFICATION TEST - VER 1.
Continued
37
AIRBAG
APPLICABILITY
All
All