Chrysler Sebring 2004 Service Manual page 2805

ELECTRICALLY HEATED SYSTEMS
*REAR WINDOW DEFOGGER INOPERATIVE (EQUIPPED WITH MAN -
UAL TEMP CONTROL) —
TEST
4 With the DRBlll , actuate the Rear Window Defogger Relay.
Examine the Rear Window Defogger Relay.
Does the Rear Window Defogger Relay click while actuating.
Yes → Go To 5
→ Go To 10
No
5 Check the Power Distribution Center fuse 6.
Is the fuse open.
Yes → Check for a short to ground and replace the PDC fuse.
→ Go To 6
No
6 Check Junction Block fuse 6.
Is the fuse open.
Yes → Check for a short to ground and replace the Junction Block fuse.
→ Go To 7
No
7 Remove the Rear Window Defogger Relay from the Junction Block.
Measure the voltage of the Fused B(+) circuit in the Rear Window Defogger Relay
connector.
Is the voltage above 10.0 volts?
Yes → Go To 8
→ Repair the open Fused B(+) circuit from PDC fuse #6.
No
8 Remove the Rear Window Defogger Relay from the Junction Block.
Install a known good relay in the Rear Window Defogger Relay connector.
Turn the ignition on.
Toggle the Rear Window Defogger switch and observe the indicator.
Does the Rear Window Defogger indicator illuminate?
Yes → Replace the original Rear Window Defogger Relay.
→ Go To 9
No
9 Reinstall relay(s).
Gain access to the A/C Heater Control C1 connector.
Backprobe and measure the voltage of the Fused Rear Window Defogger Relay
Output circuit in the C1 connector.
With the DRBIII , actuate the Rear Defogger Relay.
Does the voltage toggle above 10.0 volts?
Yes → Replace the A/C Heater Control.
→ Repair the Fused Rear Window Defogger Relay Output circuit for
No
Continued
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
an open.
Perform BODY VERIFICATION TEST - VER 1.
256
APPLICABILITY
All
All
All
All
All
All