Chrysler Sebring 2004 Service Manual page 2816

A/C BLEND DR INPUT OPEN/SHORT TO GROUND - MTC —
TEST
3 Turn the ignition off.
Disconnect the A/C - Heater Control C1 harness connector.
Disconnect the Body Control Module C2 harness connector.
Measure the resistance between ground and the Temperature Select Signal circuit.
Is the resistance below 10K ohms?
Yes → Repair the Temperature Select Signal circuit for a short to
→ Go To 4
No
4 Turn the ignition off.
Disconnect the A/C - Heater Control C1 harness connector.
Disconnect the Body Control Module C2 harness connector.
Measure the resistance between the Sensor Ground circuit and the Temperature
Select Signal circuit at the A/C - Heater Control C1 harness connector.
Is the resistance below 10K ohms?
Yes → Repair the Temperature Select Signal circuit for a short to the
→ Go To 5
No
5 Turn the ignition off.
Disconnect the A/C - Heater Control C1 harness connector.
Disconnect the Body Control Module C2 harness connector.
Measure the resistance of the Temperature Select Signal circuit between the A/C -
Heater Control C1 harness connector and the BCM C2 harness connector.
Is the resistance below 5.0 ohms?
Yes → Go To 6
→ Repair the Temperature Select Signal circuit for an open.
No
ACTION
ground.
Calibration must be performed after repair/replacement is com-
pleted.
Perform BODY VERIFICATION TEST - VER 1.
Sensor Ground circuit.
Calibration must be performed after repair/replacement is com-
pleted.
Perform BODY VERIFICATION TEST - VER 1.
Calibration must be performed after repair/replacement is com-
pleted.
Perform BODY VERIFICATION TEST - VER 1.
267
HEATING & A/C
Continued
APPLICABILITY
All
All
All