Table of Contents
Advertisement
P1686 NO SKIM BUS MESSAGE RECEIVED —
TEST
5
WARNING: KEEP CLEAR OF THE ENGINE'S MOVING PARTS.
NOTE: The conditions that set the DTC are not present at this time. The
following list may help in identifying the intermittent condition.
With the engine running and at normal operating temperature, monitor the DRB
parameters related to the DTC while wiggling the wiring harness. Look for param-
eter values to change and/or a DTC to set.
Review the DTC When Monitored and Set Conditions. If possible, try to duplicate the
conditions under which the DTC was set.
Refer to any Technical Service Bulletins (TSB) that may apply.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wiring harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Were any of the above conditions present?
Yes → Repair as necessary
→ Test Complete.
No
ACTION
Perform POWERTRAIN VERIFICATION TEST VER - 2.
DRIVEABILITY - GAS
Continued
231
APPLICABILITY
All
Advertisement
Table of Contents
