Chrysler Sebring 2004 Service Manual page 2812

Symptom:
*LOW BEAM HEADLAMPS WILL NOT TURN ON
MULTIFUNCTION SWITCH
JUNCTION BLOCK
FUSED LOW BEAM OUTPUT CIRCUIT OPEN
HEADLAMP DELAY RELAY
HEADLAMP DELAY RELAY
JUNCTION BLOCK
BODY CONTROL MODULE
OPEN FUSED B+ TO JUNCTION BLOCK
B+ CIRCUIT FUSE
FUSED B+ CIRCUIT SHORT TO GROUND
TEST
1 Turn the Headlamps on.
With the DRBIII read the Multifunction Switch voltage.
Does the DRBIII display Multifunction Switch voltage between 1.4 and 1.8 volts?
Yes → Go To 2
→ Replace the Multifunction Switch.
No
2 With the DRBIII actuate the Headlamp Delay Relay.
Listen to or touch the Headlamp Delay Relay.
Does the relay click during actuation?
Yes → Go To 3
→ Go To 5
No
3 Remove the Headlamp Delay Relay.
Measure the voltage of the Fused B+ circuit in the Headlamp Delay Relay.
Is the voltage above 10.0 volts?
Yes → Go To 4
→ Replace the Junction Block
No
4 Remove the Headlamp Delay Relay from the junction block.
Ensure fuses 13 and 12 are OK and are installed in the junction block.
Connect a jumper wire between the Fused B+ Circuit and the Headlamp Delay Relay
Output Circuit in the relay connector.
Did the low beam headlamps come on?
Yes → Replace the Headlamp Delay Relay.
→ Repair the Fused Low Beam Output Circuit for an open condition.
No
POSSIBLE CAUSES
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
EXTERIOR LIGHTING
263
APPLICABILITY
All
All
All
All