Chrysler Sebring 2004 Service Manual page 2902

*HORN INOPERATIVE —
TEST
13 Reinstall Fuse #8 in the Junction Block.
Remove the Horn Relay from the Junction Block.
Temporarily remove the Headlamp Delay Relay from the Junction Block.
Reinstall the Headlamp Delay Relay in place of the Horn Relay.
With the DRBIII , actuate the HORN RELAY.
Does the Horn sound while actuating the Horn Relay?
Yes → Replace the Horn Relay.
→ Go To 14
No
14 Remove the Headlamp Delay Relay from the Horn Relay location in the Junction
Block.
Reinstall the Headlamp Delay Relay to its original location.
Measure the voltage of the Fused B(+) circuits at the Horn Relay connector.
Is the voltage above 10.0 volts at each cavity?
Yes → Go To 15
→ Replace the Junction Block.
No
15 Remove the Horn Relay from the junction block.
Remove the BCM from the junction block.
Connect a jumper wire between the Fused B(+) circuit and the Horn Relay Control
circuit at the Horn Relay connector.
Measure the voltage of the Horn Relay Control circuit (cavity 7) in the BCM internal
connector.
Is the voltage above 10.0 volts?
Yes → Replace the Body Control Module.
→ Replace the Junction Block.
No
Continued
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
IGNITION, POWER, ACCESSORY
353
APPLICABILITY
All
All
All