Loss Of Ignition Run Only - Chrysler Sebring 2004 Service Manual

AIRBAG
Symptom:

LOSS OF IGNITION RUN ONLY

When Monitored and Set Condition:
LOSS OF IGNITION RUN ONLY
When Monitored: With the ignition in the run position the module monitors the Run Only
circuit for proper system voltage.
Set Condition: If the voltage on the Run Only circuit drops below 6.0 volts, the code will
set.
IGNITION SWITCH OUTPUT RUN CIRCUIT OPEN
FUSED IGNITION SWITCH OUTPUT RUN CIRCUIT OPEN
ACM, FUSED IGNITION OUTPUT RUN CIRCUIT OPEN
CHECKING FOR A SHORTED RUN CIRCUIT
FUSED IGNITION SWITCH OUTPUT RUN CIRCUIT SHORT TO GROUND
ACM, FUSED IGNITION RUN CIRCUIT SHORT TO GROUND
STORED CODE OR INTERMITTENT CONDITION
ACTIVE CODE PRESENT
TEST
1 Turn the ignition on.
Ensure the battery is fully charged.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
DETERMINE ACTIVE OR STORED DTC:
ACM - ACTIVE DTC:
ACM - STORED DTC
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
2 Turn the ignition off.
Remove and inspect the Airbag Run circuit fuse.
Is the Fuse open?
Yes → Go To 3
→ Go To 6
No
POSSIBLE CAUSES
ACTION
Go To 2
Go To 9
86
APPLICABILITY
All
All