Chrysler Sebring 2004 Service Manual page 3000

Symptom:
*VTSS INDICATOR INOPERATIVE
VTSS INDICATOR LAMP TEST
OPEN FUSED B(+) CIRCUIT
OPEN JUNCTION BLOCK
INSTRUMENT CLUSTER
OPEN VTSS LED
VTSS INDICATOR DRIVER CIRCUIT OPEN
BODY CONTROL MODULE INTERNAL MALFUNCTION
OPEN FUSE #7
TEST
1 With the DRBIII , actuate the VTSS LAMP.
Does the VTSS Lamp flash while actuating the Lamp?
Yes → Replace the Body Control Module.
→ Go To 2
No
2 Remove and inspect Fuse #7 in the Junction Block.
Is the fuse open?
Yes → Inspect/repair the Fused B(+) circuit for a short to ground.
→ Go To 3
No
3 Reinstall Fuse #7 in the Junction Block.
Gain access to the Junction Block connector C7.
While back probing, measure the voltage of the Fused B(+) circuit at the Junction
Block connector C7.
Is the voltage above 10.0 volts?
Yes → Go To 4
→ Replace the Junction Block.
No
4 Disconnect the Instrument Cluster harness connector.
Measure the voltage of the Fused B(+ ) circuit at cavity 21.
Is the voltage above 10.0 volts?
Yes → Go To 5
→ Repair the Fused B(+) circuit for an open.
No
POSSIBLE CAUSES
ACTION
Perform VTSS VERIFICATION TEST - 1A.
Replace the Fuse.
Perform VTSS VERIFICATION TEST - 1A.
Perform VTSS VERIFICATION TEST - 1A.
Perform VTSS VERIFICATION TEST - 1A.
VEHICLE THEFT/SECURITY
451
APPLICABILITY
All
All
All
All