Door Ajar - Chrysler Sebring 2004 Service Manual

Symptom:
*DECKLID AJAR CIRCUIT OPEN
DECKLID RELEASE SOLENOID/AJAR SWITCH CASE GROUND OPEN
INTERMITTENT CONDITION
DECKLID RELEASE SOLENOID/AJAR SWITCH
DECKLID AJAR SWITCH SENSE CIRCUIT OPEN
BODY CONTROL MODULE INTERNAL MALFUNCTION
TEST
1 Open the Decklid.
With the DRBIII in Inputs/Outputs, read the DECKLID AJAR SW state.
Does the DRBIII display CLOSED?
Yes → The condition that caused this symptom is currently not present.
No
2 Disconnect the Decklid Ajar switch connector.
Using a 12-volt Test Light connected to 12-volts, test the Case Ground for continuity.
Does the light illuminate?
Yes → Go To 3
No
3 Disconnect the Decklid Ajar Switch connector.
With the DRBIII in Inputs/Outputs, read the DECKLID AJAR SW state.
Connect a jumper wire between Sense circuit and body ground.
Does the DRBIII display DECKLID AJAR SW: CLOSED?
Yes → Replace the Decklid Release Solenoid/Ajar Switch.
No
4 Disconnect the Body Control Module C4 harness connector.
Disconnect the Decklid Ajar Switch harness connector.
Measure the resistance of the Sense circuit.
Is the resistance below 5.0 ohms?
Yes → Replace the Body Control Module.
No
POSSIBLE CAUSES
ACTION
Inspect the related wiring harness for a possible intermittent
condition. Look for any chafed, pierced, pinched or partially
broken wires.
Perform BODY VERIFICATION TEST - VER 1.
→ Go To 2
→ Repair the Case Ground for an open.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
→ Go To 4
Perform BODY VERIFICATION TEST - VER 1.
→ Repair the Decklid Ajar Switch Sense circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
241

DOOR AJAR

APPLICABILITY
All
All
All
All