Chrysler Sebring 2004 Service Manual page 2844

BLEND DOOR OUTPUT SHORT TO BATTERY - ATC & MTC —
TEST
4 Turn the ignition off.
Reconnect the Body Control Module C2 harness connector.
Turn the ignition on.
With the DRBIII , record and erase Body Computer DTC's.
Turn the ignition off.
Disconnect the C200 in-line connector (HVAC) located in the center of the instrument
panel above the accelerator pedal.
Start the engine.
With the DRBIII in Miscellaneous, actuate Calibrate HVAC Door Motors.
With the DRBIII , read the Body Computer DTCs.
Does the DRBIII display: XXXX Door Output Short To Batt?
Yes → Go To 5
→ Go To 6
No
5 Turn the ignition off.
Disconnect the C200 in-line connector (HVAC) located in the center of the instrument
panel above the accelerator pedal.
Disconnect the Body Control Module C2 harness connector.
Measure the resistance between the Common Door Driver circuit and the Blend Door
Driver circuit, the Mode Door Driver circuit, and the Recirc Door Driver circuit in the
BCM C2 harness connector.
Is the resistance below 10K ohms on any of the circuits?
Yes → Repair all door driver circuits with a resistance below 10K ohms
→ Replace and program the Body Control Module in accordance
No
6 Turn the ignition off.
Disconnect the C200 in-line connector (HVAC) located in the center of the instrument
panel above the accelerator pedal.
Disconnect the Mode Door Actuator harness connector.
Measure the resistance between the Common Door Driver circuit and the Mode Door
Driver circuit.
Is the resistance below 10K ohms?
Yes → Repair the Mode Door Driver circuit for a short to the Common
→ Go To 7
No
ACTION
for short to the Common Door Driver circuit.
Calibration must be performed after repair/replacement is com-
pleted.
Perform BODY VERIFICATION TEST - VER 1.
with the Service Information.
Calibration must be performed after repair/replacement is com-
pleted.
Perform BODY VERIFICATION TEST - VER 1.
Door Driver circuit.
Calibration must be performed after repair/replacement is com-
pleted.
Perform BODY VERIFICATION TEST - VER 1.
295
HEATING & A/C
Continued
APPLICABILITY
All
All
All