Chrysler Sebring 2004 Service Manual page 2760

*NO RESPONSE FROM PCM (PCI BUS) - SBEC —
TEST
3 Turn the ignition off.
Disconnect the PCM C2 harness connector.
Disconnect the BCM C3 harness connector.
Measure the resistance of the PCI bus circuit between the PCM C2 connector and the
BCM C3 connector.
Is the resistance below 5.0 ohms?
Yes → Replace the Body Control Module in accordance with the service
No
ACTION
information.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
→ Repair the PCI Bus circuit for an open.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
Continued
211
COMMUNICATION
APPLICABILITY
All