Chrysler Sebring 2004 Service Manual page 2919

INSTRUMENT CLUSTER
Symptom:
*ENGINE COOLANT TEMPERATURE INDICATOR NOT OPERAT-
ING PROPERLY
DTC PRESENT
ENGINE COOLANT TEMPERATURE WARNING INDICATOR LED
INSTRUMENT CLUSTER
TEST
1 NOTE: Ensure that there is communication between the PCM, BCM, and the
Instrument Cluster before proceeding with this test.
Perform the Instrument Cluster Self Test.
Turn the ignition off.
NOTE: The Instrument Cluster will illuminate the Engine Coolant Temper-
ature indicator at 124°C (255°F). The indicator will turn off at 121°C (250°F).
Press and hold the Trip Reset button.
Turn the ignition to the Unlock position.
Release the Trip Reset button when the Self Test begins.
Observe the Engine Coolant Temperature Warning indicator during the Self Test.
Did the Engine Coolant Temperature indicator illuminate for approximately 4
seconds and then turn of
Yes → Go To 2
→ Go To 3
No
2 Turn the ignition on.
Using the DRBIII read DTC's.
Are there any DTC's present?
Yes → Refer to symptom list for problems related to DRIVEABILITY.
→ Go To 3
No
3 Turn the ignition off.
Remove the Engine Coolant Temperature Warning Indicator LED.
Using a DVOM, select Diode Mode and connect the leads across the LED.
CAUTION: Ensure that the RED lead is on the + of the LED.
Did the Engine Coolant Temperature Warning Indicator LED illuminate?
Yes → Replace the Instrument Cluster in accordance with the Service
→ Replace the Engine Coolant Temperature Warning Indicator LED
No
POSSIBLE CAUSES
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Information.
Perform BODY VERIFICATION TEST - VER 1.
in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
370
APPLICABILITY
All
All
All