Chrysler Sebring 2004 Service Manual page 2864

Symptom List:
MODE DOOR FEEDBACK FAILURE - ATC & MTC
MODE DOOR STALL TEST FAILURE - ATC & MTC
Test Note: All symptoms listed above are diagnosed using the same tests.
The title for the tests will be MODE DOOR FEEDBACK
FAILURE - ATC & MTC.
When Monitored and Set Condition:
MODE DOOR FEEDBACK FAILURE - ATC & MTC
When Monitored: With the ignition on.
Set Condition: This DTC will set if the BCM detects voltage below 0.06 volts or above 4.8
volts on the Blend Door Feedback Signal input/Mode Door Feedback Signal input.
MODE DOOR STALL TEST FAILURE - ATC & MTC
When Monitored: During HVAC motor calibration.
Set Condition: This DTC will set if the BCM is unable to detect the end of travel for the
mode door.
CHECK CODE(S) PRESENT
BLEND DOOR FEEDBACK/STALLTEST FAILURE DTC PRESENT
ADDITIONAL FEEDBACK/STALL TEST FAILURE DTCS PRESENT
MODE DOOR FEEDBACK SIGNAL CIRCUIT SHORTED TO THE DOOR DRIVER CIRCUIT(S)
MODE DOOR, LINKAGE, ACTUATOR
MODE DOOR DRIVER CIRCUIT OPEN
COMMON DOOR DRIVER CIRCUIT OPEN
BODY CONTROL MODULE
SENSOR GROUND CIRCUIT OPEN
BODY CONTROL MODULE
5 VOLT SUPPLY CIRCUIT SHORTED TO GROUND
5 VOLT SUPPLY CIRCUIT OPEN
5 VOLT SUPPLY CIRCUIT SHORTED TO SENSOR GROUND CIRCUIT
BODY CONTROL MODULE
MODE DOOR, LINKAGE, ACTUATOR
MODE DOOR FEEDBACK SIGNAL CIRCUIT SHORTED TO GROUND
MODE DOOR FEEDBACK SIGNAL CIRCUIT OPEN
MODE DOOR FEEDBACK SIGNAL CIRCUIT SHORTED TO SENSOR GROUND CIRCUIT
POSSIBLE CAUSES
315
HEATING & A/C