Chrysler Sebring 2004 Service Manual page 2647

AIRBAG
Symptom:
NO PCI TRANSMISSION
When Monitored and Set Condition:
NO PCI TRANSMISSION
When Monitored: With the ignition on and the module transmitting information on the
BUS.
Set Condition: The code will set immediately if the onboard diagnostic cannot detect the
module transmitting information on the BUS. NOTE: Any Bus Failure will may cause a
stored code to set.
AIRBAG CONTROL MODULE - ACM
STORED CODE OR INTERMITTENT CONDITION
ACTIVE CODE PRESENT
TEST
1 Turn the ignition on.
NOTE: Ensure the battery is fully charged.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
From the list below, select the appropriate module and DTC type for the this
diagnostic trouble code.
DETERMINE ACTIVE OR STORED DTC
ACM - ACTIVE
ACM - STORED
NOTE: When reconnecting airbag system components the Ignition must be
turned off and the Battery must be disconnected.
2 WARNING: TO AVOID PERSONAL INJURY OR DEATH, DISCONNECT THE
BATTERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY
TIME, IT MUST BE REPLACED. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND PERSONAL INJURY OR DEATH.
If there are no possible causes remaining, view repair.
Repair
POSSIBLE CAUSES
ACTION
Go To 2
Go To 3
Replace the Airbag Control Module in accordance with Service
Instructions.
Perform __AIRBAG VERIFICATION TEST - VER 1.
98
APPLICABILITY
All
All