Chrysler Sebring 2004 Service Manual page 2809

EXTERIOR LIGHTING
Symptom:
*HIGH BEAM HEADLAMPS WILL NOT TURN ON
OPEN FUSED B+
FUSED LOW BEAM OUTPUT CIRCUIT SHORT TO GROUND
FUSED HIGH BEAM OUTPUT CIRCUIT SHORT TO GROUND
HEADLAMP DELAY RELAY
FUSED LOW BEAM OUTPUT CIRCUIT OPEN
HEADLAMP DELAY RELAY CONTROL CIRCUIT OPEN
MULTIFUNCTION SWITCH
TEST
1 Turn the Headlamps on.
Gain access to the High Beam Headlamp Relay in the junction block.
Cycle the high beam switch on the multifunction switch and listen to or feel the High
Beam Relay for a click.
Does the relay click?
Yes → Go To 2
→ Go To 3
No
2 Remove the Headlamp Delay Relay.
Measure the voltage of the Fused B+ circuit at the Headlamp Delay Relay connector.
Is the voltage above 10.0 volts?
Yes → Go To 3
→ Repair the open fused B+ circuit from PDC fuse 4.
No
3 Remove fuse 4 from the PDC.
Disconnect the Multifunction Switch connector.
Measure the resistance of the Fused Low Beam Output Circuit to ground.
Is the resistance below 5.0 ohms?
Yes → Repair the Fused Low Beam output circuit for a short to ground
→ Go To 4
No
4 Remove the Headlamp Delay Relay from the junction block.
Disconnect the Multifunction Switch connector.
Measure the resistance of the Headlamp Delay Relay Control circuit to ground.
Is the resistance below 5.0 ohms?
Yes → Repair the Fused High Beam Output Circuit for a short to ground
→ Go To 5
No
POSSIBLE CAUSES
ACTION
Perform BODY VERIFICATION TEST - VER 1.
condition.
Perform BODY VERIFICATION TEST - VER 1.
condition.
Perform BODY VERIFICATION TEST - VER 1.
260
APPLICABILITY
All
All
All
All