Table of Contents
Advertisement
DRIVEABILITY - NGC
P0452-NVLD PRESSURE SWITCH SENSE CIRCUIT LOW —
TEST
7
Turn the ignition off.
Disconnect the EVAP Purge Solenoid harness connector.
Disconnect the Powertrain Control Module harness connectors.
Measure the resistance between ground and the (K52) EVAP Purge Sol Control
circuit at the EVAP Purge Solenoid harness connector.
Is the resistance below 5.0 ohms?
Yes → Repair the short to ground in the (K52) EVAP Purge Sol Control
→ NOTE: Before continuing, check the PCM harness connector
No
ACTION
circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
terminals for corrosion, damage or terminal push out. Repair as
necessary. Replace and program the Powertrain Control Module
in accordance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
396
Continued
APPLICABILITY
All
Advertisement
Table of Contents
