Chrysler Sebring 2004 Service Manual page 2583

AIRBAG
DRIVER CURTAIN SQUIB CIRCUIT OPEN —
TEST
2 WARNING: TURN IGNITION OFF, DISCONNECT THE BATTERY AND WAIT
TWO MINUTES BEFORE PROCEEDING.
Disconnect the Driver Curtain Airbag connector(s).
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED CURTAIN AIRBAG
FACE DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO
THE AIR IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERI-
OUS OR FATAL INJURY.
Connect the appropriate Load Tool to the Driver Curtain Airbag connector(s).
WARNING: TURN IGNITION ON, THEN RECONNECT THE BATTERY.
NOTE: Check connectors - Clean and repair as necessary.
With the DRBIII , read active Airbag Control Module DTC's.
Does the DRBIII show DRIVER CURTAIN SQUIB CIRCUIT OPEN?
Yes → Go To 3
→ Replace Driver Curtain Airbag in accordance with the Service
No
3 WARNING: TURN IGNITION OFF, DISCONNECT THE BATTERY AND WAIT
TWO MINUTES BEFORE PROCEEDING.
Disconnect the Airbag Load Tool from the Driver Curtain Airbag connector(s).
Disconnect the Airbag Control Module Connector(s).
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool ACM Adapter to the Airbag Control Module
connector(s).
Measure the resistance of the Curtain Squib Line 1 and Line 2 circuits between the
Load Tool ACM adaptor and the Curtain Airbag connector.
Is the resistance below 1.0 ohms on both circuits?
Yes → Replace the Airbag Control Module in accordance with the Service
→ Repair open or high resistance in the Driver Curtain Squib Line
No
ACTION
Information.
Perform __AIRBAG VERIFICATION TEST - VER 1.
information. WARNING: IF THE AIRBAG CONTROL MODULE
IS DROPPED AT ANY TIME, IT MUST BE REPLACED.
Perform __AIRBAG VERIFICATION TEST - VER 1.
1 or Line 2 circuits.
Perform __AIRBAG VERIFICATION TEST - VER 1.
Continued
34
APPLICABILITY
All
All