Table of Contents
Advertisement
DECKLID RELEASE SWITCH FAILURE —
TEST
4
If there are no possible causes remaining, view repair.
Repair
5
Turn the ignition off.
Note: Visually inspect the related wiring harness. Look for any chafed,
pierced, pinched, or partially broken wires.
Note: Visually inspect the related wire harness connectors. Look for broken,
bent, pushed out, or corroded terminals.
Were any problems found?
Yes → Repair wiring harness/connectors as necessary.
→ Test Complete.
No
ACTION
Replace the Body Control Module Module.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOOR LOCKS/RKE
Continued
401
APPLICABILITY
All
All
Advertisement
Table of Contents
