Symptom:
*NO RESPONSE FROM SENTRY KEY IMMOBILIZER MODULE
ATTEMPT TO COMMUNICATE WITH THE BCM
GROUND CIRCUIT OPEN
FUSED IGNITION SWITCH OUTPUT CIRCUIT OPEN
FUSED B(+) CIRCUIT OPEN
SENTRY KEY IMMOBILIZER MODULE (SKIM)
PCI BUS CIRCUIT OPEN
BODY CONTROL MODULE
TEST
1
Turn the ignition on.
With the DRB, enter Body then Body Computer.
Was the DRB able to I/D or communicate with the BCM?
Yes → Go To 2
No
2
Turn the ignition off.
Disconnect the SKIM harness connector.
Using a 12-volt test light connected to 12-volts, probe the ground circuit.
Is the test light illuminated?
Yes → Go To 3
No
3
Turn the ignition off.
Disconnect the SKIM harness connector.
Turn the ignition on.
Using a 12-volt test light connected to ground, probe the Fused Ignition Switch
Output circuit.
Is the test light illuminated?
Yes → Go To 4
No
POSSIBLE CAUSES
ACTION
→ Refer to the symptom list for problems related to no communica-
tion with the BCM.
Perform SKIS VERIFICATION.
→ Repair the Ground circuit for an open.
Perform SKIS VERIFICATION.
→ Repair the Fused Ignition Switch Output circuit for an open.
Refer to the wiring diagrams in the service information.
Perform SKIS VERIFICATION.
221
COMMUNICATION
APPLICABILITY
All
All
All