Chrysler Sebring 2004 Service Manual page 2956

Symptom:
RKE PROGRAM MODE ENTERED WITHOUT PROGRAM REQUEST
When Monitored and Set Condition:
RKE PROGRAM MODE ENTERED WITHOUT PROGRAM REQUEST
When Monitored: Continuously.
Set Condition: The BCM receives an indication from the RKE module that it has entered
program mode without the BCM requesting so.
REMOTE KEYLESS ENTRY MODULE
RKE PROGRAM MODE ENTERED WITHOUT PROGRAM REQUEST
TEST
1 Note: This DTC will only set if the BCM receives an indication from the RKE
module that it has entered program mode without the BCM requesting so.
Replace the Remote Keyless Entry Module and program a transmitter..
With the DRBIII, clear DTCs.
Operate the Door Locks several times with the RKE transmitter.
With the DRBIII , read DTC's.
Did this DTC reset?
Yes → Replace the Body Control Module in accordance with the Service
→ If the replaced module was a test unit only, replace the RKE
No
POSSIBLE CAUSES
ACTION
Information.
Perform BODY VERIFICATION TEST - VER 1.
module. Program all transmitters used with this vehicle.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOOR LOCKS/RKE
407
APPLICABILITY
All