Exterior Lighting - Chrysler Sebring 2004 Service Manual

EXTERIOR LIGHTING

Symptom:
*HEADLAMP DELAY RELAY INOPERATIVE
FUSED B+ CIRCUIT OPEN
HEADLAMP DELAY RELAY
OPEN FUSE
INTERMITTENT CONDITION
BODY CONTROL MODULE
TEST
1 Turn the ignition off.
Check the PDC fuse 4.
Is the fuse open?
Yes → Replace the open Fuse.
→ Go To 2
No
2 Turn the ignition on.
Measure the voltage of the Fused B+ Circuit between the PDC and the Junction
Block.
Is the voltage above 10.0 volts?
Yes → Go To 3
→ Repair the Fuse B+ Circuit for an open condition.
No
3 Turn the ignition off.
Install a known good relay in place of the Headlamp Delay Relay.
Actuate the Headlamp Delay system.
Does the Headlamp Delay system operate normally?
Yes → Replace the Headlamp Delay Relay.
→ Go To 4
No
4 Turn the ignition on.
With the DRBIII , read the Ignition Voltage.
Does the DRBIII display voltage above 10.0 volts?
Yes → Replace the Body Control Module.
→ The condition that caused the symptom is currently not present.
No
POSSIBLE CAUSES
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Inspect the related wiring for a possible intermittent condition.
Look for any chafed, pierced, pinched, or partially broken wires.
Perform BODY VERIFICATION TEST - VER 1.
258
APPLICABILITY
All
All
All
All