Chrysler Sebring 2004 Service Manual page 2851

HEATING & A/C
BLEND DOOR OUTPUT SHORT TO GROUND - ATC & MTC —
TEST
10 Turn the ignition off
Ensure the Body Control Module C2 harness connector is connected.
Reconnect the C200 in-line connector (HVAC) located in the center of the instrument
panel above the accelerator pedal.
Disconnect the Blend Door Actuator harness connector.
Turn the ignition on.
With the DRBIII , record and erase Body Computer DTC's.
Cycle the ignition switch.
Start the engine.
With the DRBIII in Miscellaneous, actuate Calibrate HVAC Door Motors.
With the DRBIII , read the Body Computer DTCs.
Does the DRBIII display: XXXX Door Output Short To Ground?
Yes → Go To 11
→ Replace the Blend Door Actuator in accordance with the Service
No
11 Disconnect the C200 in-line connector (HVAC) located in the center of the instrument
panel above the accelerator pedal.
Disconnect the Recirculation Door Actuator harness connector.
Measure the resistance between the Recirculation Door Driver circuit and the
Common Door Driver circuit.
Is the resistance below 10K ohms?
Yes → Repair the Recirculation Door Driver circuit for a short to the
→ Replace the Recirculation Door Actuator in accordance with the
No
12 Turn the ignition off.
NOTE: Visually inspect the related wiring harness and circuits. Look for
any chafed, pierced, pinched, or partially broken wires.
NOTE: Visually inspect the related wiring harness connectors. Look for
broken, bent, pushed out, or corroded terminals.
NOTE: Refer to any Technical Service Bulletins (TSB) that may apply.
Were any problems found?
Yes → Repair as necessary.
→ Test Complete.
No
ACTION
Information.
Calibration must be performed after repair/replacement is com-
pleted.
Perform BODY VERIFICATION TEST - VER 1.
Common Door Driver circuit.
Calibration must be performed after repair/replacement is com-
pleted.
Perform BODY VERIFICATION TEST - VER 1.
Service Information.
Calibration must be performed after repair/replacement is com-
pleted.
Perform BODY VERIFICATION TEST - VER 1.
Calibration must be performed after repair/replacement is com-
pleted.
Perform BODY VERIFICATION TEST - VER 1.
302
Continued
APPLICABILITY
All
All
All