Chrysler Sebring 2004 Service Manual page 2192

P0072-AMBIENT TEMP SENSOR LOW —
TEST
4 Turn the ignition off.
Disconnect the Ambient Air Temperature Sensor harness connector.
Disconnect the PCM harness connector.
Measure the resistance between the (K25) AAT Signal circuit and the (K4) Sensor
ground circuit in the Ambient Air Temperature Sensor harness connector.
Is the resistance below 100 ohms?
Yes → Repair the (K4) Sensor ground shorted to the (K25) AAT Signal
→ Go To 5
No
5 NOTE: Before continuing, check the PCM harness connector terminals for
corrosion, damage, or terminal push out. Repair as necessary.
If there are no possible causes remaining, view repair.
Repair
ACTION
circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Replace and program the Powertrain Control Module in accor-
dance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
DRIVEABILITY - NGC
Continued
263
APPLICABILITY
All
All