Chrysler Sebring 2004 Service Manual page 2848

BLEND DOOR OUTPUT SHORT TO GROUND - ATC & MTC —
BODY CONTROL MODULE
MODE DOOR DRIVER CIRCUIT SHORTED TO COMMON DOOR DRIVER CIRCUIT
MODE DOOR ACTUATOR
BLEND DOOR DRIVER CIRCUIT SHORTED TO COMMON DOOR DRIVER CIRCUIT
BLEND DOOR ACTUATOR
RECIRCULATION DOOR DRIVER CIRCUIT SHORTED TO COMMON DOOR DRIVER CIRCUIT
RECIRCULATION DOOR ACTUATOR
WIRING CAUSING INTERMITTENT CONDITION
TEST
1 Turn the ignition on.
With the DRBIII , record and erase Body Computer DTC's.
Cycle the ignition switch.
Start the engine.
With the DRBIII in Miscellaneous, actuate Calibrate HVAC Door Motors.
With the DRBIII , read the Body Computer DTCs.
Does the DRBIII display: XXXX Door Output Short To Ground?
Yes → Go To 2
→ Go To 12
No
2 Turn the ignition off.
Disconnect the Body Control Module C2 harness connector.
Measure the resistance between ground and each of the Door Driver circuits (Blend,
Mode, Recirc, & Common).
Is the resistance below 10K ohms on any of the circuits?
Yes → Repair all Door Driver circuits with a resistance below 10K ohms
→ Go To 3
No
3 Turn the ignition off.
Disconnect the Body Control Module C2 harness connector.
Measure the resistance between Sensor Ground and each of the Door Driver circuits
(Blend, Mode, Recirc, & Common).
Is the resistance below 10K ohms on any of the circuits?
Yes → Repair all Door Driver circuits with a resistance below 10K ohms
→ Go To 4
No
POSSIBLE CAUSES
ACTION
for a short to ground.
Calibration must be performed after repair/replacement is com-
pleted.
Perform BODY VERIFICATION TEST - VER 1.
for a short to Sensor Ground.
Calibration must be performed after repair/replacement is com-
pleted.
Perform BODY VERIFICATION TEST - VER 1.
299
HEATING & A/C
Continued
APPLICABILITY
All
All
All