Chrysler Sebring 2004 Service Manual page 2190

P0071-AMBIENT TEMP SENSOR PERFORMANCE —
TEST
6 Turn the ignition off.
Disconnect the Ambient Air Temperature Sensor harness connector.
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Measure the resistance of the (K167) Sensor ground circuit from the Ambient Air
Temperature Sensor harness connector to the appropriate terminal of special tool
#8815.
Is the resistance below 5.0 ohms?
Yes → NOTE: Before continuing, check the PCM harness connector
→ Repair the open in the (K4) Sensor ground circuit.
No
7 Turn the ignition off.
Disconnect the Ambient Air Temperature Sensor harness connector.
Disconnect the PCM harness connector.
Measure the resistance between ground and the (K25) AAT Signal circuit.
Is the resistance below 100 ohms?
Yes → Repair the short to ground in the (K25) AAT Signal circuit.
→ Go To 8
No
8 Turn the ignition off.
Disconnect the Ambient Air Temperature Sensor harness connector.
Disconnect the PCM harness connector.
Measure the resistance between the (K25) AAT Signal circuit and the (K4) Sensor
ground circuit in the Ambient Air Temperature Sensor harness connector.
Is the resistance below 100 ohms?
Yes → Repair the Sensor ground shorted to the (K25) AAT Signal circuit.
→ NOTE: Before continuing, check the PCM harness connector
No
ACTION
terminals for corrosion, damage, or terminal push out. Repair as
necessary. Replace and program the Powertrain Contorl Module
in accordance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
terminals for corrosion, damage or terminal push out. Repair as
necessary. Replace and program the Powertrain Control Module
in accordance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
DRIVEABILITY - NGC
261
Continued
APPLICABILITY
All
All
All