Chrysler Sebring 2004 Service Manual page 2952

DOOR LOCK SWITCH FAILURE —
TEST
4 Turn the ignition off.
Disconnect the BCM C4 harness connector.
Disconnect the Driver Door Lock Switch connector.
Turn the ignition on.
Measure the voltage of the Driver Door Lock Switch Mux circuit.
Is there any voltage present?
Yes → Repair the Driver Door Lock Switch Mux circuit for a short to
→ Go To 5
No
5 Turn the ignition off.
Disconnect the BCM C4 harness connector.
Disconnect the Passenger Door Lock Switch connector.
Turn the ignition on.
Measure the voltage of the Passenger Door Lock Switch Mux circuit.
Is there any voltage present?
Yes → Repair the Passenger Door Lock Switch Mux circuit for a short to
→ Go To 6
No
6 If there are no possible causes remaining, view repair.
Repair
7 Turn the ignition off.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
Check for either switch possibly sticking
Were any problems found?
Yes → Repair or replace as necessary.
→ Test Complete.
No
ACTION
voltage.
Perform BODY VERIFICATION TEST - VER 1.
voltage.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOOR LOCKS/RKE
Continued
403
APPLICABILITY
All
All
All
All