9
Root Commands
DIGitize
Syntax
DIGitize
This command is used to start the single- shot data acquisition.
Supported Model
U2351A, U2352A, U2353A, U2354A, U2355A, U2356A, U2331A
Remarks
• Use the
• In general condition, there are four trigger conditions; post trigger,
See Also:
ACQuire:POINts
ACQuire:SRATe
STOP
WAVeform:COMPlete?
WAVeform:DATA?
78
STOP
command to stop the single- shot acquisition before the
numer of point stated in ACQuire:POINts is reached.
pre- trigger, middle trigger and NONE. However, user can only select
post and delay trigger modes when used in NONE trigger mode.
U2300A Series USB DAQ Programming Guide