Rcl - Agilent Technologies U2300A Series Programming Manual

*RCL

Syntax
*RCL {1|2}
This command recalls the instrument state stored in the defined storage
location. It is not possible to recall the instrument state from a storage
location that is empty or was deleted. When shipped from the factory,
storage locations 1 through 2 are empty.
Use the *SAV command to store the current instrument state.
Supported Model
U2351A, U2352A, U2353A, U2354A, U2355A, U2356A, U2331A
Remarks
• The instrument has two storage locations in the non- volatile memory to
• Before recalling a stored state, the instrument will perform the
• A Factory Reset
Example
The following command recalls the instrument state previously stored in
location 1.
*RCL 1
See Also
*SAV
U2300A Series USB DAQ Programming Guide
store instrument states. You can only recall a state from a location that
contains a previously stored state.
equivalent of a Factory Reset
(*RST
stored in the memory. Once a state is stored, it remains until it is
overwritten or specifically deleted.
(*RST command).
command) has no effect on the configurations
IEEE-488 Common Command 6
41