Apply:sawtooth - Agilent Technologies U2300A Series Programming Manual

APPLy:SAWTooth

Syntax
APPLy:SAWTooth [<amplitude>, <offset>] (@<ch_list>)
This command is used to configure a sawtooth waveform pattern onto the
FIFO buffer. It outputs a sawtooth wave with the specified amplitude and
DC offset. The waveform is generated after executing the OUTPut ON
command.
Supported Model
U2351A, U2353A, U2355A, U2356A, U2331A
Parameters
Remarks
• Amplitude must be larger than zero.
• Amplitude + Offset ≤ 10; Amplitude * (—1) + Offset ≥ —10.
Query Returned Format
<mode>, <amplitude>, <offset>
U2300A Series USB DAQ Programming Guide
Name Type
<amplitude> Float
<offset> Float
<ch_list> Numeric
Range of Values
<amplitude>: amplitude units [V]
<offset>: offset voltage [V]
U2331A: 201 through 202
APPLy Subsystem 3
Default Value
10
0.0
N/A
19