Agilent Technologies U2300A Series Programming Manual page 55

5 Standard Event Summary
6 Master Summary
7 Not used
• Use the <enable_value> parameter to specify which bits will be enabled.
• The Status Byte enable register is cleared when you execute the *SRE 0
• Refer to
Return Format
The query command reads the enable register and returns a decimal value
which corresponds to the binary- weighted sum of all bits set in the
register. For example, if bit 3 (decimal value = 8) and bit 7 (decimal value
= 128) are enabled, the query command will return "+136".
Example
The following command enables bit 4 (decimal value = 16) in the enable
register.
*SRE 16
The following query returns which bits are enabled in the register.
*SRE?
Typical Response: +16
See Also
*STB?
U2300A Series USB DAQ Programming Guide
32
64
Not used
The decimal value specified corresponds to the binary- weighted sum of
the bits you wish to enable in the register. For example, to enable bit 1
(decimal value = 2), bit 3 (decimal value = 8), and bit 6 (decimal value
= 64), the corresponding decimal value would be 74 (2 + 8 + 64).
command.
Figure 6- 1, status system diagram for more information.
IEEE-488 Common Command
One or more bits are set in the Standard Event Register
(bits must be enabled, see
One or more bits are set in the Status Byte Register and
may generate a Request for Service (RQS)
Bits must be enabled using the
Always zero
*ESE command)
*SRE command
6
47