5
CONFigure Subsystem
CONFigure Subsystem Introduction
The CONFigure command provides the most flexible way to program the
instrument for measurements. When you execute this command, the
instrument uses default values for the requested measurement
configuration, for example the MEASure? command. However, the
measurement is not automatically started and you can change some
measurement attributes before actually initiating the measurement. This
enables you to incrementally change the instrument's configuration from
the default conditions.
The CONFigure subsystem commands are as below:
• CONFigure:DIGital:DIRection
• CONFigure:TIMEbase:SOURce
• CONFigure:TIMEbase:ExternalCLocK
• CONFifure:SSI
26
U2300A Series USB DAQ Programming Guide