Agilent Technologies U2300A Series Programming Manual page 167

U2300A Series USB DAQ Programming Guide
• 305, "Not able to perform requested operation; user- defined waveform
not set",
• 305, "Not able to perform requested operation; sampling rate cannot
be 0 with user- defined output",
• 307, "Incorrectly configured ref channel",
• 308, "Channel not able to perform requested operation",
• 308, "Channel not able to perform requested operation: currently in
differential mode",
• 309, "Incorrectly formatted channel list",
• 311, "Not able to specify resolution with Auto range",
• 521, "Input buffer overflow",
• 522, "Output buffer overflow",
• 531, "Insufficient memory",
• 532, "Not able to achieve requested resolution",
• 602, "Self- test failed; RAM read/write",
• 626, "I/O processor failed self- test",
• 705, "Cal: aborted",
• 706, "Cal: value out of range",
• 747, "Calibration failed",
• 748, "Cal checksum failed, internal data",
• 748, "Cal: invalid while cal in progress",
• 748, "Firmware and FPGA revision mismatch"
Error Messages 16
159