Trigger:atrigger:source - Agilent Technologies U2300A Series Programming Manual

TRIGger:ATRiGger:SOURce

Syntax
TRIGger:ATRiGger:SOURce <src>
This function sets the physical pin for the analog trigger.

TRIGger:ATRiGger:SOURce?

The query command returns a string value representing the trigger source
selection of analog trigger control.
Supported Device
U2351A, U2352A, U2353A, U2354A, U2355A, U2356A, U2331A
Parameters
Remarks
• Only post and pre- trigger modes can be used if trigger source is set to
• Input range should be configured well. The HTHReshold must be less
• To activate SONE trigger, users are required to run the
• The SONE trigger detection only comes into effect during the
• The SONE parameter refers to the first entry in
Query Returned Format
<src> ::= {EXTAP|SONE}
U2300A Series USB DAQ Programming Guide
Item Type
<src> String
SONE.
than the maximum input range while the LTHReshold must be larger
than minimum input range.
before or after analog output ("OUTPut ON").
command execution.
Range of Values
EXTAP: From external analog trigger pin
SONE: Source from first scanned channel for
multiplexing DAQ device
TRIGger Subsystem
Default Value
EXTAP
DIGitize
command
DIGitize
ROUTe:SCAN
command.
14
141