Agilent Technologies U2300A Series Programming Manual page 165

U2300A Series USB DAQ Programming Guide
-140, "Character data error",
•
-141, "Invalid character data",
•
-144, "Character data too long",
•
-148, "Character data not allowed",
•
-150, "String data error",
•
-151, "Invalid string data",
•
-158, "String data not allowed",
•
-160, "Block data error",
•
-161, "Invalid block data",
•
-168, "Block data not allowed",
•
-200, "Execution error",
•
-220, "Parameter error",
•
-221, "Settings conflict",
•
-221, "Settings conflict; amplitude and offset out of reference voltage
•
range",
-221, "Settings conflict; high threshold is lower than low threshold",
•
-221, "Settings conflict; analog trigger level beyond range because of
•
analog trigger source",
-221, "Settings conflict; sampling rate beyond range because of
•
number of channel",
-221, "Settings conflict; acquisition points beyond range because of
•
number of channel",
-221, "Settings conflict; waveform points beyond range because of
•
number of channel",
-221, "Settings conflict; unsupported trigger mode",
•
-221, "Settings conflict; unsupported trigger mode because of analog
•
trigger source",
-222: Data out of range; external clock is set above instrument's
•
capability
-223, "Too much data",
•
-224, "Illegal parameter value",
•
-300, "Device specific error",
•
-310, "System error",
•
Error Messages 16
157