*SAV
Syntax
*SAV {1|2}
This command stores (saves) the current instrument state in the
designated storage location. Any state previously stored in the same
location is overwritten (with no error is generated).
Use the
Remarks
• The instrument has two storage locations in non- volatile memory to
• A Factory Reset
• The following parameters are saved in *SAV:
U2300A Series USB DAQ Programming Guide
*RCL
command to recall a stored instrument state.
store instrument states. You can store the instrument state in any of
the five locations, but you can only recall a state from a location that
contains a previously stored state.
(*RST
stored in the memory. Once a state is stored, it remains until it is
overwritten or specifically deleted.
•
[SENSe:]VOLTage:RANGe
•
[SENSe:]VOLTage:POLarity
•
[SENSe:]VOLTage:STYPe
•
[SENSe:]COUNter:FUNCtion
•
[SENSe:]COUNter:GATE:POLarity
•
[SENSe:]COUNter:GATE:SOURce
•
[SENSe:]COUNter:GATE:CONTrol
•
[SENSe:]COUNter:CLocK:EXTernal
•
[SENSe:]COUNter:CLocK:SOURce
•
[SENSe:]COUNter:TOTalize:IVALue
•
[SENSe:]COUNter:TOTalize:UDOWn:SOURce
•
[SENSe:]COUNter:TOTalize:UDOWn:DIRection
•
SOURce:VOLTage:POLarity
•
SOURce:VOLTage:RSouRCe
command) does not affect the configurations
IEEE-488 Common Command
6
43