Lldp Example Configuration - Lenovo ThinkSystem NE2552E Application Manual

LLDP Example Configuration

1. Turn LLDP on globally.
2. Set the global LLDP timer features.
3. Set LLDP options for each port.
4. Enable syslog reporting.
5. Verify the configuration settings:
6. View remote device information as needed.
© Copyright Lenovo 2018
NE2552E(config)# lldp enable
NE2552E(config)# lldp refresh-interval 30
NE2552E(config)# lldp transmission-delay 2 (No more often than 2 sec.)
NE2552E(config)# lldp holdtime-multiplier 4
NE2552E(config)# lldp reinit-delay 2
NE2552E(config)# lldp trap-notification-interval 5
NE2552E(config)# interface port <n>
NE2552E(config-if)# lldp admin-status tx_rx (Transmit and receive LLDP)
NE2552E(config-if)# lldp trap-notification
NE2552E(config-if)# lldp tlv all
NE2552E(config-if)# exit
NE2552E(config)# logging log lldp
NE2552E(config)# show lldp
NE2552E(config)# show lldp remote-device
or
NE2552E(config)# show lldp remote-device <index number>
or
NE2552E(config)# show lldp remote-devices detail
(Transmit each 30 seconds)
(Remote hold 4 intervals)
(Wait 2 sec. after reinit.)
(Minimum 5 sec. between)
(Select a switch port)
(Enable SNMP trap notifications)
(Transmit all optional information)
Chapter 33: Link Layer Discovery Protocol
475