Configure The Vlag - Lenovo ThinkSystem NE2552E Application Manual

Configure the VLAG

1. Configure the VLAN for VLAG 1 ports. Once the VLAN s ready, the ISL ports are
automatically added to it.
2. Place the VLAG 1 port(s) in a port LAG:
3. Assign the LAG to the VLAG:
4. Continue by configuring all required VLAGs on VLAG Peer 1 and then repeat the
configuration for VLAG Peer 2.
5. Enable VLAG globally.
6. Verify the completed configuration:
© Copyright Lenovo 2018
NE2552E(config)# vlan 100
NE2552E(config-vlan)# exit
NE2552E(config)# interface port 8
NE2552E(config-if)# switchport mode trunk
NE2552E(config-if)# exit
Note: In MSTP mode, VLANs are automatically mapped to CIST.
NE2552E(config)# interface port 8
NE2552E(config-if)# lacp mode active
NE2552E(config-if)# lacp key 1000
NE2552E(config-if)# exit
NE2552E(config)# vlag adminkey 1000 enable
For each corresponding VLAG on the peer, the port LAG type (dynamic or static),
the port's VLAN, and STP mode and ID must be the same as on VLAG Peer 1.
NE2552E(config)# vlag enable
NE2552E(config)# show vlag information
Chapter 11: Virtual Link Aggregation Groups
203