Lenovo ThinkSystem NE2552E Application Manual page 208

4. Turn on VRRP and configure the Virtual Interface Router.
5. Set the priority of Virtual Router 1 to 101, so that it becomes the Master.
6. Configure the ISL ports and place them into a port LAG:
7. Configure the upstream ports.
8. Configure the server ports.
208
NE2552E Application Guide for ENOS 8.4
NE2552E(config)# router vrrp
NE2552E(config-vrrp)# enable
NE2552E(config-vrrp)# virtual-router 1 virtual-router-id 1
NE2552E(config-vrrp)# virtual-router 1 interface 3
NE2552E(config-vrrp)# virtual-router 1 address 10.0.1.100
NE2552E(config-vrrp)# virtual-router 1 enable
NE2552E(config-vrrp)# virtual-router 1 priority 101
NE2552E(config-vrrp)# exit
NE2552E(config)# interface port 4-5
NE2552E(config-if)# switchport mode trunk
NE2552E(config-if)# lacp mode active
NE2552E(config-if)# lacp key 2000
NE2552E(config-if)# exit
Note: In this case, a dynamic LAG is shown. A static LAG could be configured
instead.
NE2552E(config)# interface port 1
NE2552E(config-if)# switchport access vlan 10
NE2552E(config-if)# exit
NE2552E(config)# interface port 2
NE2552E(config-if)# switchport access vlan 20
NE2552E(config-if)# exit
NE2552E(config)# interface port 10
NE2552E(config-if)# switchport access vlan 100
NE2552E(config-if)# exit
NE2552E(config)# interface port 11
NE2552E(config-if)# switchport access vlan 100
NE2552E(config-if)# exit
NE2552E(config)# interface port 12
NE2552E(config-if)# switchport access vlan 100
NE2552E(config-if)# exit