RSTP Configuration Example
1. Configure port and VLAN membership on the switch.
2. Set the Spanning Tree mode to Rapid Spanning Tree.
3. Configure RSTP parameters.
4. Configure port parameters:
188
NE2552E Application Guide for ENOS 8.4
This section provides steps to configure RSTP.
NE2552E(config)# spanning-tree mode rstp
NE2552E(config)# spanning-tree stp 1 bridge priority 8192
NE2552E(config)# spanning-tree stp 1 bridge hello-time 5
NE2552E(config)# spanning-tree stp 1 bridge forward-delay 20
NE2552E(config)# spanning-tree stp 1 bridge maximum-age 30
NE2552E(config)# no spanning-tree stp 1 enable
NE2552E(config)# interface port 3
NE2552E(config-if)# spanning-tree stp 1 priority 240
NE2552E(config-if)# spanning-tree stp 1 path-cost 500
NE2552E(config-if)# no spanning-tree stp 1 enable
NE2552E(config-if)# exit